Add fabric routing instructions
Change-Id: I8a31144c053751089eba0b63237fcc10d2eb0aa7
diff --git a/pronto_deployment_guide/hw_installation.rst b/pronto_deployment_guide/hw_installation.rst
index e0543d2..df60ea7 100644
--- a/pronto_deployment_guide/hw_installation.rst
+++ b/pronto_deployment_guide/hw_installation.rst
@@ -218,7 +218,19 @@
For example ``10.0.0.32/27`` as a DHCP block would take up 1/4 of the ADMIN
prefix.
-14. Add Cables between physical interfaces on the devices
+14. Add router IP reservations to the IP Prefix for both Fabric prefixes. These
+ are IP addresses that:
+
+ - Have the last usable address in range (in a ``/25``, this would be
+ ``.126`` or ``.254``)
+
+ - Have a ``Status`` of ``Reserved``, and the VRF, Tenant Group, and Tenant
+ set.
+
+ - The Description must start with the word ``router``, such as: ``router
+ for for leaf1 Fabric``
+
+15. Add Cables between physical interfaces on the devices
TODO: Explain the cabling topology
@@ -342,11 +354,16 @@
One manual change needs to be made to this output - edit the
``inventory/host_vars/mgmtserver1.stage1.menlo.yml`` file and add the following
-to the bottom of the file, replacing the IP addresses with *only the lowest
-numbered IP address* the management server has on each VLAN (if >1 IP address
-is assigned to a VLAN or Interface, the DHCP server will fail to run). This
-configures the `netplan <https://netplan.io>`_ on the management server, and
-will be automated away soon::
+to the bottom of the file, replacing the IP addresses with the management
+server IP address for each segment.
+
+In the case of the Fabric that has two leaves and IP ranges, add the Management
+server IP address used for the leaf that it is connected to, and then add a
+route for the other IP address range for the non-Management-connected leaf that
+is via the Fabric router address in that range.
+
+This configures the `netplan <https://netplan.io>`_ on the management server,
+and will be automated away soon::
# added manually
netprep_netplan:
@@ -364,7 +381,11 @@
id: 801
link: eno2
addresses:
- - 10.0.1.1/25
+ - 10.0.1.129/25
+ routes:
+ - to: 10.0.1.0/25
+ via: 10.0.1.254
+ weight: 100
Using the ``inventory/example-aether.ini`` as a template, create an
:doc:`ansible inventory <ansible:user_guide/intro_inventory>` file for the