OFTest OpenFlow Testing Framework

Introduction

OFTest is a Python based framework for OpenFlow switch testing.

In this project we use OFTest to ensure OpenFlow conformance of the switches used to implement the network infrastructure of the OpenCord project.

At this moment the switches supported are Accton switches. For more information abot that check the wiki page at wiki.opencord.org

This code base was forked from macauleycheng which was forked from floodlight. This documentationn aims to describe the specific test cases developed for OpenCord. To get started on the basics of OFTest please check their documentation.

How it is organized

This codebase is organized by branches. Each OFDPA release correspond to a different branch. At this moment the following releases are available:

  • i12_17 (master)
  • i19
  • i12
  • ga2.0
  • EA3

The OFDPA release i12_17 is the current stable version utilized by the cord project and is the master branch. The test case collection for OpenCord are under the folder ofdpa. They are listed under the section Test case collection.

Installing OFTest

You can check out OFTest with git with the following commands:

sudo apt-get install python python-pip python-dev python-lxml -y
sudo pip install ncclient
sudo pip install scapy pycripto
sudo apt-get install python-ecdsa git
git clone git://github.com/opencord/fabric-oftest

Quick Start

Make sure your switch is running and trying to connect to a controller on the machine where you're running oft (normally port 6653).

cd fabric-oftest
./oft --list --test-dir=ofdpa flows
sudo ./oft -V1.3 --test-dir=ofdpa flows.PacketInArp -i 1@veth1 -i 2@veth3

This command assumes you connected the switch port 1 to interface veth1 in the OFtest server and port 2 to veth3

Testing a different release

Don't forget to make sure your switch is attempting to establish a OpenFlow connection to the OFTest server. To test the ga2.0 release do the following:

cd fabric-oftest
git checkout ga2.0
sudo ./oft -V1.3 --test-dir=ofdpa flows -i 12@eth1 -i 24@eth2

Test Results

The following tests are implemented and these are their results.

Test Resultsi12_1.7ga2.0EA3
/0Ucastfalseokok
/24UnicastTaggedokokok
/32UnicastTaggedokokok
/24ECMPL3okokok
/32ECMPL3okokok
/24ECMPVPNokokok
/32ECMPVPNokokok
/32VPNokokok
/24VPNokokok
EcmpGroupMod??ok
PacketInArpokokok
MTU1500okokok
MplsTerminationokokok
MplsFwd?okok
L2FloodQinQokokok
L2UnicastTaggedokokok
L3McastToL3ok??
L3McastToL2ok??
FloodGroupMod??ok
PacketInUDPokokok
Unfiltered?ok?