{{- /*
# Copyright 2018-present Open Networking Foundation
# Copyright 2018 Intel Corporation
#
# Licensed under the Apache License, Version 2.0 (the "License");
# you may not use this file except in compliance with the License.
# You may obtain a copy of the License at
#
# http://www.apache.org/licenses/LICENSE-2.0
#
# Unless required by applicable law or agreed to in writing, software
# distributed under the License is distributed on an "AS IS" BASIS,
# WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
# See the License for the specific language governing permissions and
# limitations under the License.
*/ -}}

This is the instruction to configure your eNodeB to work with ONF M-CORD. You can find architecture illustration in assets/mcord-architecture.png.

1. Configure eNodeB with the correct MME information.
    export MMEIP=[node IP]
    export MMEPORT="36412"

    You can change MMEPORT by overriding "Values.config.mme.s1ap.sctp_port_external".

2. Make sure UE's SIM card information is configured in hss.yaml.

3. Attach UE to OMEC.