diff --git a/omec/omec-data-plane/values.yaml b/omec/omec-data-plane/values.yaml
index 60a454b..3738e9f 100644
--- a/omec/omec-data-plane/values.yaml
+++ b/omec/omec-data-plane/values.yaml
@@ -41,23 +41,24 @@
 config:
   sriov:
     enabled: true
+    # Provide interface used as a SR-IOV PF
+    # If your cluster has multiple nodes with different interface names,
+    # simply provide the whole list
     resourceList:
-      - resourceName: sriov_vfio
-        selectors:
-          pfNames:
-            - eno1
-          drivers:
-            - vfio-pci
-      - resourceName: sriov_netdevice
-        selectors:
-          pfNames:
-            - eno1
-          drivers:
-            - ixgbevf
+      # Provide PF name with its VFs are bounded to vfio-pci driver
+      vfio:
+        pfNames:
+          - eno1
+      # Provide PF name with its VFs bounded to PF's driver
+      # The driver name must be specified to prevent one interface is
+      # registered to both vfio and netdevice resource pools
+      # NOTE: netDevice is required to use CDN service
+      #netDevice:
+      #  pfNames:
+      #    - eno2
+      #  drivers:
+      #    - ixgbevf
   spgwu:
-    spgwc:
-      addr: spgwc
-      port: 21
     # Provide the S1U and SGI networks facing device name and IP address
     s1u:
       device: s1u-net
@@ -65,6 +66,17 @@
     sgi:
       device: sgi-net
       ip: 13.1.1.3/24
+    cpComm:
+      # IMPORTANT: when you deploy CP and DP to separate clusters, enable nodePort
+      # from both cpComm(omec-control-plane) and dpComm(omec-data-plane) and
+      # set "addr" to remote cluster's entry node IP and
+      # "port" to cpComm.nodePort.port value configured in omec-control-plane.
+      addr: spgwc
+      port: 21
+    dpComm:
+      nodePort:
+        enabled: false
+        port: 30020
     # Set "--no-pci --vdev eth_af_packet0,iface=s1u-net --vdev eth_af_packet1,iface=sgi-net"
     # when sriov is disabled
     devices: ""