diff --git a/generated/onudynamicpowermanagementcontrol.go b/generated/onudynamicpowermanagementcontrol.go
index da0180f..ebb2f39 100644
--- a/generated/onudynamicpowermanagementcontrol.go
+++ b/generated/onudynamicpowermanagementcontrol.go
@@ -27,11 +27,11 @@
 
 // OnuDynamicPowerManagementControlClassID is the 16-bit ID for the OMCI
 // Managed entity ONU dynamic power management control
-const OnuDynamicPowerManagementControlClassID ClassID = ClassID(336)
+const OnuDynamicPowerManagementControlClassID = ClassID(336) // 0x0150
 
 var onudynamicpowermanagementcontrolBME *ManagedEntityDefinition
 
-// OnuDynamicPowerManagementControl (class ID #336)
+// OnuDynamicPowerManagementControl (Class ID: #336 / 0x0150)
 //	This ME models the ONU's ability to enter power conservation modes in cooperation with the OLT
 //	in an ITU-T G.987 system. [ITUT G.987.3] originally specified two alternative modes, doze and
 //	cyclic sleep. The subsequent revision of [ITUT G.987.3] simplified the specification providing a
@@ -44,38 +44,56 @@
 //
 //	Attributes
 //		Managed Entity Id
-//			Managed entity ID: This attribute uniquely identifies each instance of this ME. There is only
-//			one instance, number 0. (R) (mandatory) (2-bytes)
+//			This attribute uniquely identifies each instance of this ME. There is only one instance, number
+//			0. (R) (mandatory) (2-bytes)
 //
 //		Power Reduction Management Capability
+//			This attribute declares the ONU's support for managed power conservation modes, as defined in
+//			[ITUT G.987.3]. It is a bit map in which the bit value 0 indicates no support for the specified
+//			mode, while the bit value 1 indicates that the ONU does support the specified mode. (R)
+//			(mandatory) (1-byte)
+//
+//			Codepoints are assigned as follows:
+//
+//			Value	Meaning
+//
+//			0	No support for power reduction
+//
+//			1	Doze mode supported
+//
+//			2	Cyclic sleep mode supported
+//
+//			3	Both doze and cyclic sleep modes supported
+//
+//			4	Watchful sleep mode supported
+//
 //			5..255	Reserved
 //
 //		Power Reduction Management Mode
-//			Power reduction management mode: This attribute enables one or more of the ONU's managed power
-//			conservation modes. It is a bit map in which the bit value 0 disables the mode, while the value
-//			1 enables the mode. Bit assignments are the same as those of the power reduction management
-//			capability attribute. The default value of each bit is 0. (R,-W) (mandatory) (1-byte)
+//			This attribute enables one or more of the ONU's managed power conservation modes. It is a bit
+//			map in which the bit value 0 disables the mode, while the value 1 enables the mode. Bit
+//			assignments are the same as those of the power reduction management capability attribute. The
+//			default value of each bit is 0. (R,-W) (mandatory) (1-byte)
 //
 //		Itransinit
-//			Itransinit:	This attribute is the ONU vendor's statement of the complete transceiver
-//			initialization time: the worst-case time required for the ONU to regain full functionality when
-//			leaving the asleep state in cyclic sleep mode or low-power state in watchful sleep mode (i.e.,
-//			turning on both the receiver and the transmitter and acquiring synchronization to the downstream
-//			flow), measured in units of 125-us frames. The value zero indicates that the sleeping ONU can
-//			respond to a bandwidth grant without delay. (R) (mandatory) (2-bytes)
+//			This attribute is the ONU vendor's statement of the complete transceiver initialization time:
+//			the worst-case time required for the ONU to regain full functionality when leaving the asleep
+//			state in cyclic sleep mode or low-power state in watchful sleep mode (i.e., turning on both the
+//			receiver and the transmitter and acquiring synchronization to the downstream flow), measured in
+//			units of 125-us frames. The value zero indicates that the sleeping ONU can respond to a
+//			bandwidth grant without delay. (R) (mandatory) (2-bytes)
 //
 //		Itxinit
-//			Itxinit:	This attribute is the ONU vendor's statement of the transmitter initialization time:
-//			the time required for the ONU to regain full functionality when leaving the listen state (i.e.,
-//			turning on the transmitter), measured in units of 125-us frames. The value zero indicates that
-//			the dozing ONU can respond to a bandwidth grant without delay. If watchful sleep is enabled, the
-//			ONU ignores this attribute. (R) (mandatory) (2 bytes)
+//			This attribute is the ONU vendor's statement of the transmitter initialization time: the time
+//			required for the ONU to regain full functionality when leaving the listen state (i.e., turning
+//			on the transmitter), measured in units of 125-us frames. The value zero indicates that the
+//			dozing ONU can respond to a bandwidth grant without delay. If watchful sleep is enabled, the ONU
+//			ignores this attribute. (R) (mandatory) (2 bytes)
 //
 //		Maximum Sleep Interval
-//			Maximum sleep interval: The Isleep/Ilowpower attribute specifies the maximum time the ONU spends
-//			in its asleep, listen, or low-power states, as a count of 125-us frames. Local or remote events
-//			may truncate the ONU's sojourn in these states. The default value of this attribute is 0. (R,-W)
-//			(mandatory) (4-bytes)
+//			The Isleep/Ilowpower attribute specifies the maximum time the ONU spends in its asleep, listen,
+//			or low-power states, as a count of 125-us frames. Local or remote events may truncate the ONU's
+//			sojourn in these states. The default value of this attribute is 0. (R,-W) (mandatory) (4-bytes)
 //
 //		Maximum Receiver_Off Interval
 //			Maximum receiver-off interval: The Irxoff attribute specifies the maximum time the OLT can
@@ -84,30 +102,50 @@
 //			(R,-W) (mandatory) (4-bytes)
 //
 //		Minimum Aware Interval
-//			Minimum aware interval: The Iaware attribute specifies the time the ONU spends in its aware
-//			state, as a count of 125-us frames, before it re-enters asleep or listen states. Local or remote
-//			events may independently cause the ONU to enter an active state rather than returning to a sleep
-//			state. The default value of this attribute is 0. (R,-W) (mandatory) (4-bytes)
+//			The Iaware attribute specifies the time the ONU spends in its aware state, as a count of 125-us
+//			frames, before it re-enters asleep or listen states. Local or remote events may independently
+//			cause the ONU to enter an active state rather than returning to a sleep state. The default value
+//			of this attribute is 0. (R,-W) (mandatory) (4-bytes)
 //
 //		Minimum Active Held Interval
-//			Minimum active held interval: The Ihold attribute specifies the minimum time during which the
-//			ONU remains in the active held state, as a count of 125-us frames. Its initial value is zero.
-//			(R, W) (mandatory) (2-bytes)
+//			The Ihold attribute specifies the minimum time during which the ONU remains in the active held
+//			state, as a count of 125-us frames. Its initial value is zero. (R, W) (mandatory) (2-bytes)
 //
 //		Maximum Sleep Interval Extension
+//			Maximum sleep interval for doze mode specifies the maximum time the ONU spends in its listen
+//			state, as a count of 125-us frames. Local or remote events may truncate the ONU's sojourn in
+//			these states. The default value is 0.
+//
+//			Maximum sleep interval for cyclic sleep mode specifies the maximum time the ONU spends in its
+//			asleep state, as a count of 125-us frames. Local or remote events may truncate the ONU's sojourn
+//			in these states. The default value is 0. If watchful sleep is enabled, the ONU ignores this
+//			attribute.
+//
 //			(R,-W) (optional) (8-bytes)
 //
+//			This attribute designates maximum sleep interval values for doze mode and cyclic sleep mode
+//			separately. When it supports this attribute, the ONU ignores the value of the maximum sleep
+//			interval attribute.
+//
+//			Maximum sleep interval for doze mode	4-bytes
+//
+//			Maximum sleep interval for cyclic sleep mode	4-bytes
+//
 //		Ethernet Passive Optical Network Epon Capability Extension
-//			-	Configurations: ackEnable configuration = enable, Sleep indication configuration = disable,
-//			Early wake-up configuration = enable
+//			Ethernet passive optical network (EPON) capability extension: This attribute declares EPON-
+//			specific capabilities for the dynamic power management control.
+//
+//			Bits are assigned as follows.
 //
 //		Epon Setup Extension
-//			(R,-W) (optional) (1-byte)
+//			The bits are assigned as follows.
+//
+//			This attribute specifies EPON specific configurations for the dynamic power management control.
 //
 //		Missing Consecutive Bursts Threshold
-//			Missing consecutive bursts threshold: The Clobi attribute specifies the maximum number of
-//			missing consecutive scheduled bursts from the ONU that the OLT is willing to tolerate without
-//			raising an alarm. The value of this attribute defaults to 4. (R,-W) (mandatory) (4-bytes)
+//			The Clobi attribute specifies the maximum number of missing consecutive scheduled bursts from
+//			the ONU that the OLT is willing to tolerate without raising an alarm. The value of this
+//			attribute defaults to 4. (R,-W) (mandatory) (4-bytes)
 //
 type OnuDynamicPowerManagementControl struct {
 	ManagedEntityDefinition