# Deployment configuration for a single-node physical hardware POD
---
seedServer:

  # Put the IP of your CloudLab node here
  ip: '128.104.222.83'

  # User name and password used by Ansible to connect to the host for remote
  # provisioning.   Put your CloudLab username here; also add your password or
  # run ssh-agent to allow for password-less SSH login.
  user: 'acb'
  password: 'onos_test'

  #
  # *** For a single-node pod on CloudLab, you don't need to change anything below here ***
  #

  # Network address information for the head node:
  #
  # fabric_ip     - the IP address and mask bits to be used to configure the network
  #                 interface connected to the leaf - spine fabric
  #
  # management_ip - the IP address and mask bits to be used to configure the network
  #                 interface connecting the head node to the POD internal
  #                 management network. The head node will deliver DHCP addresses to
  #                 the other compute nodes over this interface
  #
  # external_ip   - the IP address and mask bits to be used to configure the network
  #                 interface connecting the head node (and the POD) to the
  #                 Internet. All traffic in the POD to external hosts will be
  #                 NAT-ed through this interface
  management_ip: '10.6.0.1/24'
  management_iface: 'eth2'
  external_iface: 'eth0'
  skipTags:
    - 'interface_config'
    - 'switch_support'
  extraVars:
    - 'on_cloudlab=True'

docker:
  imageVersion: candidate

otherNodes:
  # Experimental
  #
  # Specifies the subnet and address range that will be used to allocate IP addresses
  # to the compute nodes as they are deployed into the POD.
  fabric:
    network: 10.6.1.1/24
    range_low: 10.6.1.2
    range_high: 10.6.1.253