Update configurations for flex deployment
Change-Id: I4c567aa111104e96d3c710aca416f02294ca1164
diff --git a/flex-pod1.yml b/flex-pod1.yml
new file mode 100644
index 0000000..0a7df4a
--- /dev/null
+++ b/flex-pod1.yml
@@ -0,0 +1,75 @@
+
+# Copyright 2017-present Open Networking Foundation
+#
+# Licensed under the Apache License, Version 2.0 (the "License");
+# you may not use this file except in compliance with the License.
+# You may obtain a copy of the License at
+#
+# http://www.apache.org/licenses/LICENSE-2.0
+#
+# Unless required by applicable law or agreed to in writing, software
+# distributed under the License is distributed on an "AS IS" BASIS,
+# WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
+# See the License for the specific language governing permissions and
+# limitations under the License.
+
+
+# Deployment configuration for a physical hardware POD
+---
+
+# this is used to generate the genconfig/cord-inv file
+headnode:
+ ip: '10.192.4.62'
+ ansible_user: 'cord'
+ ansible_ssh_pass: 'cord'
+ ansible_ssh_port: 22
+
+common:
+ # set to the profile of cord you want to install
+ cord_profile: 'rcord'
+
+ # cord dir is shared to corddev VM, causing permissions issues if these aren't set
+ credentials_dir: '/opt/credentials'
+ pki_dir: '/opt/pki'
+ ssh_pki_dir: '/opt/ssh_pki'
+
+ # all of these are written to genconfig/config.yml, and needs a rework
+
+ # Network address information for the head node:
+ #
+ # fabric_ip - the IP address and mask bits to be used to configure the network
+ # interface connected to the leaf - spine fabric
+ #
+ # management_ip - the IP address and mask bits to be used to configure the network
+ # interface connecting the head node to the POD internal
+ # management network. The head node will deliver DHCP addresses to
+ # the other compute nodes over this interface
+ #
+ # external_ip - the IP address and mask bits to be used to configure the network
+ # interface connecting the head node (and the POD) to the
+ # Internet. All traffic in the POD to external hosts will be
+ # NAT-ed through this interface
+ fabric_ip: '10.6.1.1/24'
+ management_ip: '10.6.0.1/24'
+ external_ip: '10.192.4.62/20'
+ external_iface: 'enp4s0f1'
+ external_gw: '10.192.4.1'
+ skipTags:
+
+passwords:
+ compute_node: "ubuntu"
+ maas_admin: "admin"
+ maas_user: "cord"
+
+docker:
+ imageVersion: candidate
+
+otherNodes:
+ # Experimental
+ #
+ # Specifies the subnet and address range that will be used to allocate IP addresses
+ # to the compute nodes as they are deployed into the POD.
+ fabric:
+ network: 10.6.1.1/24
+ range_low: 10.6.1.2
+ range_high: 10.6.1.253