Initial revision
diff --git a/ospf6d/README b/ospf6d/README
new file mode 100644
index 0000000..b3b4d16
--- /dev/null
+++ b/ospf6d/README
@@ -0,0 +1,85 @@
+
+ Zebra OSPF daemon for IPv6 network
+
+ 2001/12/20
+
+Zebra OSPF6d is OSPF version 3 daemon which is specified by
+"OSPF for IPv6" (RFC 2740).
+
+*** NOTE ***
+ Zebra ospf6d is in development yet. It may lack some functionalities,
+ and may have some bugs. Use the latest version from the anoncvs
+ repository (http://www.zebra.org/cvs.html) !
+
+This file README is like memo yet, so please feel free to ask
+<yasu@sfc.wide.ad.jp> by E-mail. Patches will be appriciated.
+
+ospf6d's vty port was default to 2606/tcp.
+Use commands below.
+
+VIEW NODE:
+ show ipv6 ospf6
+ To see Router-ID, uptime of ospf6d, some statistics.
+
+ show ipv6 ospf6 database ...
+ This command shows LSA database. You can specify
+ LS-type/LS-ID/Advertising-Router of LSAs. '*' is recognized.
+
+ show ipv6 ospf6 interface ...
+ To see the status of the OSPF interface, and the configuration
+ like interface costs.
+
+ show ipv6 ospf6 neighbor ...
+ Shows state of neighbors and choosed (Backup) DR on the I/F.
+
+ show ipv6 ospf6 route (X::X)
+ This command shows internal routing table of the ospf6d.
+ Routes not calculated by OSPFv3 (like connected routes)
+ are not shown. If Address is specified (X::X), shows the route
+ that the address matches.
+
+ show ipv6 ospf6 route redistribute (X::X)
+ Shows the routes advertised as AS-External routes by the router
+ itself. If Address is specified (X::X), shows the route
+ that the address matches.
+
+CONFIG NODE:
+ interface NAME
+ To enter INTERFACE NODE
+
+ router ospf6 ...
+ To enter OSPF6 NODE
+
+INTERFACE NODE:
+ ipv6 ospf6 cost COST
+ Sets the interface's output cost. default 1
+
+ ipv6 ospf6 hello-interval HELLOINTERVAL
+ Sets the interface's Hello Interval. default 10
+
+ ipv6 ospf6 dead-interval DEADINTERVAL
+ Sets the interface's Router Dead Interval. default 40
+
+ ipv6 ospf6 retransmit-interval RETRANSMITINTERVAL
+ Sets the interface's Rxmt Interval. default 5
+
+ ipv6 ospf6 priority PRIORITY
+ Sets the interface's Router Priority. default 1
+
+ ipv6 ospf6 transmit-delay TRANSMITDELAY
+ Sets the interface's Inf-Trans-Delay. default 1
+
+OSPF6 NODE:
+ router-id A.B.C.D
+ Sets the router's Router-ID
+
+ interface NAME area AREA
+ Binds interface to specified Area, and start
+ sending OSPFv3 packets.
+
+Sample configuration is in ospf6d.conf.sample.
+
+--
+Yasuhiro Ohara <yasu@sfc.wide.ad.jp>
+Kunihiro Ishiguro <kunihiro@zebra.org>
+