zebra: improve interface shutdown behaviour
Linux removes IPv6 addresses when the interface is set down. Those
addresses need to be readded when the interface is set up again.
Also, an interface should not be reactivated from shutdown by configuring
an ip address.
Finally, remove the three-state logic for the shutdown setting as its
sole current use may be mild confusion.
Signed-off-by: Christian Franke <chris@opensourcerouting.org>
Signed-off-by: David Lamparter <equinox@opensourcerouting.org>
diff --git a/zebra/interface.c b/zebra/interface.c
index 51798ca..155ee02 100644
--- a/zebra/interface.c
+++ b/zebra/interface.c
@@ -56,7 +56,7 @@
zebra_if = XCALLOC (MTYPE_TMP, sizeof (struct zebra_if));
zebra_if->multicast = IF_ZEBRA_MULTICAST_UNSPEC;
- zebra_if->shutdown = IF_ZEBRA_SHUTDOWN_UNSPEC;
+ zebra_if->shutdown = IF_ZEBRA_SHUTDOWN_OFF;
#ifdef RTADV
{
@@ -378,6 +378,14 @@
{
SET_FLAG (ifp->status, ZEBRA_INTERFACE_ACTIVE);
+ if (if_data && if_data->shutdown == IF_ZEBRA_SHUTDOWN_ON)
+ {
+ if (IS_ZEBRA_DEBUG_KERNEL)
+ zlog_debug ("interface %s index %d is shutdown. Won't wake it up.",
+ ifp->name, ifp->ifindex);
+ return;
+ }
+
if_addr_wakeup (ifp);
if (IS_ZEBRA_DEBUG_KERNEL)
@@ -1095,13 +1103,16 @@
struct zebra_if *if_data;
ifp = (struct interface *) vty->index;
- ret = if_unset_flags (ifp, IFF_UP);
- if (ret < 0)
+ if (ifp->ifindex != IFINDEX_INTERNAL)
{
- vty_out (vty, "Can't shutdown interface%s", VTY_NEWLINE);
- return CMD_WARNING;
+ ret = if_unset_flags (ifp, IFF_UP);
+ if (ret < 0)
+ {
+ vty_out (vty, "Can't shutdown interface%s", VTY_NEWLINE);
+ return CMD_WARNING;
+ }
+ if_refresh (ifp);
}
- if_refresh (ifp);
if_data = ifp->info;
if_data->shutdown = IF_ZEBRA_SHUTDOWN_ON;
@@ -1119,13 +1130,23 @@
struct zebra_if *if_data;
ifp = (struct interface *) vty->index;
- ret = if_set_flags (ifp, IFF_UP | IFF_RUNNING);
- if (ret < 0)
+
+ if (ifp->ifindex != IFINDEX_INTERNAL)
{
- vty_out (vty, "Can't up interface%s", VTY_NEWLINE);
- return CMD_WARNING;
+ ret = if_set_flags (ifp, IFF_UP | IFF_RUNNING);
+ if (ret < 0)
+ {
+ vty_out (vty, "Can't up interface%s", VTY_NEWLINE);
+ return CMD_WARNING;
+ }
+ if_refresh (ifp);
+
+ /* Some addresses (in particular, IPv6 addresses on Linux) get
+ * removed when the interface goes down. They need to be readded.
+ */
+ if_addr_wakeup(ifp);
}
- if_refresh (ifp);
+
if_data = ifp->info;
if_data->shutdown = IF_ZEBRA_SHUTDOWN_OFF;
@@ -1191,11 +1212,14 @@
const char *addr_str, const char *peer_str,
const char *label)
{
+ struct zebra_if *if_data;
struct prefix_ipv4 cp;
struct connected *ifc;
struct prefix_ipv4 *p;
int ret;
+ if_data = ifp->info;
+
ret = str2prefix_ipv4 (addr_str, &cp);
if (ret <= 0)
{
@@ -1237,7 +1261,8 @@
/* In case of this route need to install kernel. */
if (! CHECK_FLAG (ifc->conf, ZEBRA_IFC_QUEUED)
- && CHECK_FLAG (ifp->status, ZEBRA_INTERFACE_ACTIVE))
+ && CHECK_FLAG (ifp->status, ZEBRA_INTERFACE_ACTIVE)
+ && !(if_data && if_data->shutdown == IF_ZEBRA_SHUTDOWN_ON))
{
/* Some system need to up the interface to set IP address. */
if (! if_is_up (ifp))
@@ -1371,11 +1396,14 @@
const char *addr_str, const char *peer_str,
const char *label, int secondary)
{
+ struct zebra_if *if_data;
struct prefix_ipv6 cp;
struct connected *ifc;
struct prefix_ipv6 *p;
int ret;
+ if_data = ifp->info;
+
ret = str2prefix_ipv6 (addr_str, &cp);
if (ret <= 0)
{
@@ -1412,7 +1440,8 @@
/* In case of this route need to install kernel. */
if (! CHECK_FLAG (ifc->conf, ZEBRA_IFC_QUEUED)
- && CHECK_FLAG (ifp->status, ZEBRA_INTERFACE_ACTIVE))
+ && CHECK_FLAG (ifp->status, ZEBRA_INTERFACE_ACTIVE)
+ && !(if_data && if_data->shutdown == IF_ZEBRA_SHUTDOWN_ON))
{
/* Some system need to up the interface to set IP address. */
if (! if_is_up (ifp))
@@ -1533,6 +1562,12 @@
vty_out (vty, "interface %s%s", ifp->name,
VTY_NEWLINE);
+ if (if_data)
+ {
+ if (if_data->shutdown == IF_ZEBRA_SHUTDOWN_ON)
+ vty_out (vty, " shutdown%s", VTY_NEWLINE);
+ }
+
if (ifp->desc)
vty_out (vty, " description %s%s", ifp->desc,
VTY_NEWLINE);
@@ -1565,9 +1600,6 @@
if (if_data)
{
- if (if_data->shutdown == IF_ZEBRA_SHUTDOWN_ON)
- vty_out (vty, " shutdown%s", VTY_NEWLINE);
-
if (if_data->multicast != IF_ZEBRA_MULTICAST_UNSPEC)
vty_out (vty, " %smulticast%s",
if_data->multicast == IF_ZEBRA_MULTICAST_ON ? "" : "no ",
diff --git a/zebra/interface.h b/zebra/interface.h
index 0777a2f..7a05348 100644
--- a/zebra/interface.h
+++ b/zebra/interface.h
@@ -34,9 +34,8 @@
#define IF_ZEBRA_MULTICAST_OFF 2
/* For interface shutdown configuration. */
-#define IF_ZEBRA_SHUTDOWN_UNSPEC 0
+#define IF_ZEBRA_SHUTDOWN_OFF 0
#define IF_ZEBRA_SHUTDOWN_ON 1
-#define IF_ZEBRA_SHUTDOWN_OFF 2
/* Router advertisement feature. */
#if (defined(LINUX_IPV6) && (defined(__GLIBC__) && __GLIBC__ >= 2 && __GLIBC_MINOR__ >= 1)) || defined(KAME)