cpudb newdb

cpudb add key=0x1

cpudb add key=0x2 local=t

cts atp trans sock server start

cts atp cos=0 vlan=1

cte reg mode=atp

# NOTE: You must un-comment the line below and replace the IP address (10.10.10.10) with
#       the value that matches your system.  The IP address must be the address of the linux
#       instance where you run your bcm_bal or bcm_sdn_agent
#
#cts atp trans sock inst dk=0x1 dip=10.10.10.10

rpc nonexthop

rpc start

# NOTE: To enable CPU packet send and receive (i.e. PacketOut and PacketIn for SDN),
#       you must un-comment the lines below and replace the IP address (10.10.10.10) and port with
#       the values that match your system.  The IP address must be the address of the linux
#       instance where you run your bcm_bal or bcm_sdn_agent, and the port must match the values used
#       in your bal_config.ini file
#       (i.e. The trap_target port number here must match trap_udp_port in bal_config.ini, and the 
#        trap_receive port here must match pkt_send_svr_listen_port in bal_config.ini)

#
#bal trap_target 10.10.10.10:50001

#bal trap_receive 10.10.10.10:50002