iwf_mode=direct
# Mapping table between Qumran and Maple: 3-separate QaX/Maple SVKs, 4-SVK4
intf_maptable=3
num_nni_ports=1
# UDP port where bcm.user listens for pkt_send messages from core (needed for remote bcm.user only!)
pkt_send_svr_listen_port=50002
# UDP port where the core listens for pkt_rcv message from bcm.user (needed for remote bcm.user only!)
trap_udp_port=50001

# The following topology configuration (currently commented out) is an alternative for bal_topology.ini.
# In case both exist, bal_topology.ini takes precedence over this configuration.
topology.num_of_devs=1
topology.num_of_pons_per_dev=2
# Allowed pon modes are: gpon|xgpon|xgs|ngpon2|epon_tdma|epon_1g|epon_10g
topology.pon_mode=xgs

#enable (y) or disable (n) loopback mode in MAC (does not need access to Maple HW if enabled)
#mac_loopback=y

# Enable NNI auto-negotiation on NNI port <n>.
# It is known to work on NNI0 with some 1G transceivers, however
# this mode wasn't tested on NNI interfaces other than 0 and/or with different transceivers.
# Use at your own risk
# autoneg_nni<n>=y