Use soak tags to run tests on the soak pod
Change-Id: Ib1a4a4ceba6c1416ca7b971e6bec93f446baad92
diff --git a/tests/dt-workflow/Voltha_DT_PODTests.robot b/tests/dt-workflow/Voltha_DT_PODTests.robot
index d4ed248..fcbba0a 100644
--- a/tests/dt-workflow/Voltha_DT_PODTests.robot
+++ b/tests/dt-workflow/Voltha_DT_PODTests.robot
@@ -68,7 +68,7 @@
[Documentation] This test reboots ONUs physically before execution all the tests
... Test case runs only on the PODs that are configured with PowerSwitch that
... controls the power off/on ONUs/OLT remotely (simulating a physical reboot)
- [Tags] functionalDt PowerSwitch RebootAllDTONUs
+ [Tags] functionalDt PowerSwitch RebootAllDTONUs soak
[Setup] Start Logging RebootAllDTONUs
[Teardown] Run Keywords Collect Logs
... AND Stop Logging RebootAllDTONUs
@@ -87,7 +87,7 @@
... Traffic sent with same vlan from different RGs,
... should reach the NNI port on the OLT with the expected double tagged vlan ids
... Inner vlans from the RG should not change
- [Tags] sanityDt
+ [Tags] sanityDt soak
[Setup] Run Keywords Start Logging SanityTestDt
... AND Setup
[Teardown] Run Keywords Collect Logs
@@ -101,7 +101,7 @@
... Delete a subscriber and validate that the pings do not succeed and state is purged
... Disable and Enable the ONU (This is to replicate the existing DT behaviour)
... Re-add the subscriber, and validate that the flows are present and pings are successful
- [Tags] functionalDt SubAddDeleteDt
+ [Tags] functionalDt SubAddDeleteDt soak
[Setup] Start Logging SubAddDeleteDt
[Teardown] Run Keywords Collect Logs
... AND Stop Logging SubAddDeleteDt
@@ -168,7 +168,7 @@
... Assuming that all the ONUs are DHCP/pingable (i.e. assuming sanityDt test was executed)
... Perform disable on the ONUs and validate that the pings do not succeed
... Perform enable on the ONUs and validate that the pings are successful
- [Tags] functionalDt DisableEnableONUDt
+ [Tags] functionalDt DisableEnableONUDt soak
[Setup] Start Logging DisableEnableONUDt
[Teardown] Run Keywords Collect Logs
... AND Stop Logging DisableEnableONUDt
@@ -268,7 +268,7 @@
... Assuming that all the ONUs are DHCP/pingable (i.e. assuming sanityDt test was executed)
... Perform disable on the OLT and validate that the pings do not succeed
... Perform enable on the OLT and validate that the pings are successful
- [Tags] functionalDt DisableEnableOLTDt
+ [Tags] functionalDt DisableEnableOLTDt soak
[Setup] Start Logging DisableEnableOLTDt
[Teardown] Run Keywords Collect Logs
... AND Stop Logging DisableEnableOLTDt