M1 - Preprovision and Activate OLT
Test Objective
- Purpose of this test is to verify new OLT can be added and activated from VOLTHA
- VOLTHA will connect with OLT physical device and create a logical device with initial ports in its data store.
- VOLTHA will send Event notifications to ONOS and PON Manager for the newly added OLT
Test Configuration
- Test Setup is as shown in Section – 7
- Maple OLT should be reachable to VOLTHA over IP interface on VLAN 4092
Test Procedure
- Issue commands to VOLTHA to simulate “Add-OLT device” message coming from PON Manager on VOLTHA
- VOLTHA should initiate connect / activate request to Maple OLT
- VOLHA will create Logical Device and Ports, and notify ONOS
- Verify the PON Management traffic between VOLTHA and OLT is tagged with Management VLAN 4092
- VOLTHA will send OLT-Activated event notification to PON Manager
- Verify OLT/ONU Status on Device Console
- ONU should drop all the traffic coming from RG
Pass/Fail Criteria
- OLT is successfully detected and activated on VOLTHA
- Logical device and port list is created on VOLTHA and ONOS
- OLT / ONU status can be seen from Device Console