M9 - Verify RG Authentication Scenario
Test Objective
- Purpose of this test is to verify RG authentication is successful with Radius / EAP method
Test Configuration
- Test Setup as shown in Section – 7
- Maple OLT should be reachable to VOLTHA over IP interface over VLAN 4092
- Maple OLT should be in active state on VOLTHA
- Broadcom ONU should be in active state on VOLTHA
- EAPOL forwarding rule should be setup on OLT and ONU
- Radius Server is in service and configured to authenticate RG
- DHCP Server should be down
Test Procedure
- Start EAP authentication process from RG by resetting RG.
- RG should send EAP-Start message and verify it reaches VOLTHA/ONOS
- EAP message exchange should happen between RG and VOLTHA/ONOS on Management VLAN 4091.
- VOLTHA/ONOS will use 802.1x method to authenticate RG EAP Identity with Radius Server
- Verify RG authentication is successful with EAP and 802.1x Radius methods
- After successful RG authentication,
- OLT/ONU should drop DHCP packets from RG
- VOLTHA/ ONOS should send DHCP Forwarding Flow to OLT and ONU
- VOLTHA/ ONOS should send Unicast Forwarding Flow to OLT and ONU
- VOLTHA/ ONOS should send IGMP Forwarding Flow to OLT and ONU
- OLT/ONU will be able to forward DHCP, Unicast and IGMP packets from RG
Pass/Fail Criteria
- RG is successfully authenticated based on its credentials in Radius Server
- DHCP, Unicast and IGMP forwarding flows are setup on OLT/ONU