M15 - Spirent - Verify 802.1ad (QinQ) Upstream
Test Objective
- Purpose of this test is to verify OLT can insert second VLAN tag (SVID) in upstream direction
Test Configuration
- Test Setup as shown in Section – 7
- Maple OLT and ONU is activated using VOLTHA
- Provision HSIA/unicast service on the OLT and connected ONU from VOLTHA
Test Procedure
- On Spirent, send untagged traffic in upstream direction
- On the receiving port end, capture traffic and verify the VLAN parameters
Pass/Fail Criteria
- Upstream:
- configure on the Spirent side to send untagged traffic (NO vlan configure)
- OLT and ONT will add 1025 ,1025 respectively (i.e. 1025,1025)
- Captured frame should contain 1025, 1025 vlan