M9 - Verify RG Authentication Scenario

Test Objective

  • Purpose of this test is to verify RG authentication is successful with Radius / EAP method

Test Configuration

  • Test Setup as shown in Section – 7
  • Maple OLT should be reachable to VOLTHA over IP interface over VLAN 4092
  • Maple OLT should be in active state on VOLTHA
  • Broadcom ONU should be in active state on VOLTHA
  • EAPOL forwarding rule should be setup on OLT and ONU
  • Radius Server is in service and configured to authenticate RG
  • DHCP Server should be down

Test Procedure

  • Start EAP authentication process from RG by resetting RG.
  • RG should send EAP-Start message and verify it reaches VOLTHA/ONOS
  • EAP message exchange should happen between RG and VOLTHA/ONOS on Management VLAN 4091.
  • VOLTHA/ONOS will use 802.1x method to authenticate RG EAP Identity with Radius Server
  • Verify RG authentication is successful with EAP and 802.1x Radius methods
  • After successful RG authentication,
  • OLT/ONU should drop DHCP packets from RG
  • VOLTHA/ ONOS should send DHCP Forwarding Flow to OLT and ONU
  • VOLTHA/ ONOS should send Unicast Forwarding Flow to OLT and ONU
  • VOLTHA/ ONOS should send IGMP Forwarding Flow to OLT and ONU
  • OLT/ONU will be able to forward DHCP, Unicast and IGMP packets from RG

Pass/Fail Criteria

  • RG is successfully authenticated based on its credentials in Radius Server
  • DHCP, Unicast and IGMP forwarding flows are setup on OLT/ONU