T4 - Verify DHCP successfully obtains an IP address

Test Objective

• Purpose of this test is to verify that the Dynamic Host Configuration Protocol (DHCP)
  • Correct Tibit OLT and ONU PON environment
  • Logical device visible in VOLTHA CLI

Test Configuration

• VOLTHA ensemble running as per deployment instructions.
• Note: The DHCP server is contained within ONOS.
• Tibit OLT and ONUs registered as ACTIVE in VOLTHA

Test Procedure

To start this procedure, execute the "ifconfig" command on the interface that will be getting assigned an IP address over DHCP and verify that IP address has not been assigned.

ifconfig ens9f1

Next, execute the following command to obtain an IP address from ONOS.

dhclient ens9f1

Note: When the dhclient command completes a common error message is displayed as follows. This mesage can safely be ignored.

mv: cannot move '/etc/resolv.conf.dhclient-new*' to '/etc/resolve.conf'

Then verify that an IP address was dynamically assigned to your interface

ifconfig ens9f1

Pass/Fail Criteria

• IP address assigned to interface