T10 - Verify DHCP Lookup

Test Objective

• Purpose of this test is to verify RG can successfully setup DHCP session

Test Configuration

• Test Setup as shown in Section – 7
• Tibit OLT should be reachable to VOLTHA over IP interface over VLAN 4090
• Tibit OLT should be in active state on VOLTHA
• Tibit ONU should be in active state on VOLTHA
• RG is authenticated with Radius
• DHCP, Unicast and IGMP forwarding flows are setup on OLT and ONU
• DHCP Server is running

Test Procedure

• Enable DHCP on RG by either resetting or enable/disable port
• DHCP Request from should be forwarded by VOLTHA/ONOS to DHCP Server
• OLT will send and receive DHCP Messages with SVID 4091 towards VOLTHA/ONOS
• DHCP should succeed and RG should have IP address
• Verify ARP, PING and Traceroute succeeds from RG to DHCP server (Not planned on it will be additional step)

Pass/Fail Criteria

• RG can receive IP address from DHCP server
• ARP, Ping and Traceroute is successful between RG and DHCP server