M10 - Verify DHCP Lookup
Test Objective
- Purpose of this test is to verify RG can successfully setup DHCP session
Test Configuration
- Test Setup as shown in Section – 7
- Maple OLT should be reachable to VOLTHA over IP interface over VLAN 4092
- Maple OLT should be in active state on VOLTHA
- Broadcom ONU should be in active state on VOLTHA
- RG is authenticated with Radius
- DHCP, Unicast and IGMP forwarding flows are setup on OLT and ONU
- DHCP Server is running
Test Procedure
- Enable DHCP on RG by either resetting or enable/disable port
- DHCP Request from should be forwarded by VOLTHA/ONOS to DHCP Server
- OLT will send and receive DHCP Messages with SVID 4091 towards VOLTHA/ONOS
- DHCP should succeed and RG should have IP address
- Verify ARP, PING and Traceroute succeeds from RG to DHCP server (Not planned on it will be additional step)
Pass/Fail Criteria
- RG can receive IP address from DHCP server
- ARP, Ping and Traceroute is successful between RG and DHCP server