blob: 2fda7abfd2c4794bec086e47d4b1a9f9a35f9051 [file] [log] [blame]
/*
* Copyright (c) 2018 - present. Boling Consulting Solutions (bcsw.net)
* Copyright 2020-present Open Networking Foundation
* Licensed under the Apache License, Version 2.0 (the "License");
* you may not use this file except in compliance with the License.
* You may obtain a copy of the License at
* http://www.apache.org/licenses/LICENSE-2.0
* Unless required by applicable law or agreed to in writing, software
* distributed under the License is distributed on an "AS IS" BASIS,
* WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
* See the License for the specific language governing permissions and
* limitations under the License.
*/
/*
* NOTE: This file was generated, manual edits will be overwritten!
*
* Generated by 'goCodeGenerator.py':
* https://github.com/cboling/OMCI-parser/README.md
*/
package generated
import "github.com/deckarep/golang-set"
// MulticastGemInterworkingTerminationPointClassID is the 16-bit ID for the OMCI
// Managed entity Multicast GEM interworking termination point
const MulticastGemInterworkingTerminationPointClassID ClassID = ClassID(281)
var multicastgeminterworkingterminationpointBME *ManagedEntityDefinition
// MulticastGemInterworkingTerminationPoint (class ID #281)
// An instance of this ME represents a point in a G-PON ONU where a multicast service interworks
// with the GEM layer. At this point, a multicast bit stream is reconstructed from GEM packets.
//
// Instances of this ME are created and deleted by the OLT.
//
// Multicast interworking GEM modes of operation
//
// The default multicast operation of the PON is where all the multicast content streams are
// carried in one PON layer connection (GEM port). This connection is then specified in the first
// entry of the IPv4 or IPv6 multicast address table, as the case may be. This single entry also
// specifies an all-inclusive IP multicast destination address (DA) range (e.g., 224.0.0.0 to
// 239.255.255.255 in the case of IPv4). The ONU then filters the traffic based on either Ethernet
// MAC addresses or IP addresses. The associated GEM port network CTP ME specifies the GEM port-ID
// that supports all multicast connections.
//
// In the default multicast operation, all multicast content streams are placed in one PON layer
// connection (GEM port). The OLT sets up a completely conventional model, a pointer from the
// multicast GEM IW termination to a GEM port network CTP. The OLT configures the GEM port-ID of
// the GEM port network CTP into the appropriate multicast address table attribute(s), along with
// the other table fields that specify the range of IP multicast DAs. The ONU accepts the entire
// multicast stream through the designated GEM port, then filters the traffic based on either the
// Ethernet MAC address or IP DA.
//
// An optional multicast configuration supports separate multicast streams carried over separate
// PON layer connections, i.e., on separate GEM ports. This permits the ONU to filter multicast
// streams at the GEM level, which is efficient in hardware, while ignoring other multicast streams
// that may be of interest to other ONUs on the PON.
//
// After configuring the explicit model for the first multicast GEM port, the OLT supports multiple
// multicast GEM ports by then configuring additional entries into the multicast address table(s),
// entries with different GEM port-IDs. The OMCI model is defined such that these ports are
// implicitly grouped together and served by the single explicit GEM port network CTP. No
// additional GEM network CTPs need be created or linked for the additional GEM ports.
//
// Several multicast GEM IW TPs can exist, each linked to separate bridge ports or mappers to serve
// different communities of interest in a complex ONU.
//
// Discovery of multicast support
//
// The OLT uses the multicast GEM IW TP entity as the means to discover the ONU's multicast
// capability. This entity is mandatory if multicast is supported by the ONU. If the OLT attempts
// to create this entity on an ONU that does not support multicast, the create command fails. The
// create or set command also fails if the OLT attempts to exploit optional features that the ONU
// does not support, e.g., in attempting to write a multicast address table with more than a single
// entry or to create multiple multicast GEM IW TPs.
//
// This ME is defined by a similarity to the unicast GEM IW TP, and a number of its attributes are
// not meaningful in a multicast context. These attributes are set to 0 and not used, as indicated
// in the following.
//
// Relationships
// An instance of this ME exists for each occurrence of transformation of GEM packets into a
// multicast data stream.
//
// Attributes
// Managed Entity Id
// Managed entity ID: This attribute uniquely identifies each instance of this ME. The value 0xFFFF
// is reserved. (R, setbycreate) (mandatory) (2-bytes)
//
// Gem Port Network Ctp Connectivity Pointer
// GEM port network CTP connectivity pointer: This attribute points to an instance of the GEM port
// network CTP that is associated with this multicast GEM IW TP. (R,-W, setbycreate) (mandatory)
// (2-bytes)
//
// Interworking Option
// (R,-W, setbycreate) (mandatory) (1-byte)
//
// Service Profile Pointer
// Service profile pointer: This attribute is set to 0 and not used. For backward compatibility, it
// may also be set to point to a MAC bridge service profile or IEEE 802.1p mapper service profile.
// (R,-W, setbycreate) (mandatory) (2-bytes)
//
// Not Used 1
// Not used 1: This attribute is set to 0 and not used. (R,-W, setbycreate) (mandatory) (2-bytes)
//
// Pptp Counter
// PPTP counter: This attribute represents the number of instances of PPTP MEs associated with this
// instance of the multicast GEM IW TP. This attribute conveys no information that is not available
// elsewhere; it may be set to 0xFF and not used. (R) (optional) (1-byte)
//
// Operational State
// Operational state: This attribute indicates whether the ME is capable of performing its
// function. Valid values are enabled (0) and disabled (1). (R) (optional) (1-byte)
//
// Gal Profile Pointer
// GAL profile pointer: This attribute is set to 0 and not used. For backward compatibility, it may
// also be set to point to a GAL Ethernet profile. (R,-W, setbycreate) (mandatory) (2-bytes)
//
// Not Used 2
// Not used 2: This attribute is set to 0 and not used. (R,-W, setbycreate) (mandatory) (1-byte)
//
// Ipv4 Multicast Address Table
// IPv4 multicast address table: This attribute maps IP multicast addresses to PON layer addresses.
// Each entry contains the following.
//
// Ipv6 Multicast Address Table
// (R,-W) (optional) (24N bytes, where N is the number of entries in the list.)
//
type MulticastGemInterworkingTerminationPoint struct {
ManagedEntityDefinition
Attributes AttributeValueMap
}
func init() {
multicastgeminterworkingterminationpointBME = &ManagedEntityDefinition{
Name: "MulticastGemInterworkingTerminationPoint",
ClassID: 281,
MessageTypes: mapset.NewSetWith(
Create,
Delete,
Get,
GetNext,
Set,
SetTable,
),
AllowedAttributeMask: 0xffc0,
AttributeDefinitions: AttributeDefinitionMap{
0: Uint16Field("ManagedEntityId", PointerAttributeType, 0x0000, 0, mapset.NewSetWith(Read, SetByCreate), false, false, false, 0),
1: Uint16Field("GemPortNetworkCtpConnectivityPointer", PointerAttributeType, 0x8000, 0, mapset.NewSetWith(Read, SetByCreate, Write), false, false, false, 1),
2: ByteField("InterworkingOption", EnumerationAttributeType, 0x4000, 0, mapset.NewSetWith(Read, SetByCreate, Write), false, false, false, 2),
3: Uint16Field("ServiceProfilePointer", PointerAttributeType, 0x2000, 0, mapset.NewSetWith(Read, SetByCreate, Write), false, false, false, 3),
4: Uint16Field("NotUsed1", UnsignedIntegerAttributeType, 0x1000, 0, mapset.NewSetWith(Read, SetByCreate, Write), false, false, false, 4),
5: ByteField("PptpCounter", UnsignedIntegerAttributeType, 0x0800, 255, mapset.NewSetWith(Read), false, true, false, 5),
6: ByteField("OperationalState", EnumerationAttributeType, 0x0400, 0, mapset.NewSetWith(Read), true, true, false, 6),
7: Uint16Field("GalProfilePointer", PointerAttributeType, 0x0200, 0, mapset.NewSetWith(Read, SetByCreate, Write), false, false, false, 7),
8: ByteField("NotUsed2", UnsignedIntegerAttributeType, 0x0100, 0, mapset.NewSetWith(Read, SetByCreate, Write), false, false, false, 8),
9: TableField("Ipv4MulticastAddressTable", TableAttributeType, 0x0080, TableInfo{nil, 12}, mapset.NewSetWith(Read, Write), false, false, false, 9),
10: TableField("Ipv6MulticastAddressTable", TableAttributeType, 0x0040, TableInfo{nil, 24}, mapset.NewSetWith(Read, Write), false, true, false, 10),
},
Access: CreatedByOlt,
Support: UnknownSupport,
Alarms: AlarmMap{
0: "Deprecated",
},
}
}
// NewMulticastGemInterworkingTerminationPoint (class ID 281) creates the basic
// Managed Entity definition that is used to validate an ME of this type that
// is received from or transmitted to the OMCC.
func NewMulticastGemInterworkingTerminationPoint(params ...ParamData) (*ManagedEntity, OmciErrors) {
return NewManagedEntity(*multicastgeminterworkingterminationpointBME, params...)
}