podconfig/rcord-physical-example.yml

---
# Copyright 2017-present Open Networking Foundation
#
# Licensed under the Apache License, Version 2.0 (the "License");
# you may not use this file except in compliance with the License.
# You may obtain a copy of the License at
#
# http://www.apache.org/licenses/LICENSE-2.0
#
# Unless required by applicable law or agreed to in writing, software
# distributed under the License is distributed on an "AS IS" BASIS,
# WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
# See the License for the specific language governing permissions and
# limitations under the License.

# rcord-physical-example Pod Config
# Example configuration for a physical R-CORD pod

cord_scenario: cord
cord_profile: rcord

# Bring up the corddev VM. This is the `build` node as specified in ansible
# inventory below.
vagrant_vms:
 - 'corddev'

# Location of the cord_profile directory to be mounted in the `corddev` VM by
# Vagrant.
#
# host_cord_profile_dir: "/path_to/cord_profile"

# Set these directory paths if the defaults aren't suitable, or if deploying
# multiple pods from the same source tree where the credentials, keys, and
# profile should differ.
#
# credentials_dir: '/path_to/credentials'
# pki_dir: '/path_to/pki'
# ssh_pki_dir: '/path_to/ssh_pki'

# Variables
# IP address used for the ONOS Fabric
fabric_ip: '10.6.1.1/24'

# IP and range of the management network, which MaaS serves DHCP
management_ip: '10.6.0.1/24'
management_network: '10.6.0.0/24'

# External gateway IP address and range that the head node is on
external_ip: '10.80.1.1/24'

# name or IP of the POD head node, used to SSH to the head node. You can also
# specify the head node user here in user@hostname format.  This could also be
# `cord@headnode.site1.opencord.org` as specified later in inventory, if
# external DNS is set up.
headnode: 'cord@10.80.1.200'

# the external IP on the head node and docker registry (on the head node)
external_gw: '10.80.1.200'
deploy_docker_registry: "10.80.1.200:5000"

# Makefile targets
# primary build target (the final MaaS build step in this case)
build_targets:
  - 'setup-automation'

copy_cord_prereqs:
  - 'config-ssh-key'

skipTags:
  - 'set_compute_node_password'

# Wait until headnode prepped before building containers, for consistent DNS
docker_images_prereqs:
  - 'prep-headnode'

# Inventory for ansible, used to generate inventory.ini
# There must be a config, build, head, and compute sections
inventory_groups:

  config:
    localhost:
      ansible_connection: local

  build:
    corddev:

  head:
    headnode.site1.opencord.org:
      ansible_host: 10.80.1.200
      ansible_port: 22
      ansible_user: cord
      ansible_ssh_pass: cordpass

  compute: