| # Deployment configuration for a physical hardware POD |
| --- |
| seedServer: |
| ip: '10.90.0.251' |
| # User name and password used by Ansible to connect to the host for remote |
| # provisioning. These default values are used for automated testing, change |
| # with care. |
| user: 'cord' |
| password: 'cord' |
| # Network address information for the head node: |
| # |
| # fabric_ip - the IP address and mask bits to be used to configure the network |
| # interface connected to the leaf - spine fabric |
| # |
| # management_ip - the IP address and mask bits to be used to configure the network |
| # interface connecting the head node to the POD internal |
| # management network. The head node will deliver DHCP addresses to |
| # the other compute nodes over this interface |
| # |
| # external_ip - the IP address and mask bits to be used to configure the network |
| # interface connecting the head node (and the POD) to the |
| # Internet. All traffic in the POD to external hosts will be |
| # NAT-ed through this interface |
| fabric_ip: '10.6.1.1/24' |
| management_ip: '10.6.0.1/24' |
| external_ip: '10.90.0.251/16' |
| external_iface: 'eth0' |
| external_gw: '10.90.0.1' |
| skipTags: |
| |
| docker: |
| imageVersion: candidate |
| |
| otherNodes: |
| # Experimental |
| # |
| # Specifies the subnet and address range that will be used to allocate IP addresses |
| # to the compute nodes as they are deployed into the POD. |
| fabric: |
| network: 10.6.1.1/24 |
| range_low: 10.6.1.2 |
| range_high: 10.6.1.253 |