blob: 07cb22235c2cbdbecd6d08115e877f925a3ecdd3 [file] [log] [blame]
# Deployment configuration for a phyical hardware POD
---
seedServer:
# IP address of the head node
ip: '10.90.0.2'
# If the head node is being accessed via a tunnel or reponds to SSH on a non-
# standard port, the port value should be set.
# port: '2022'
# User name and password used by Ansible to connect to the host for remote
# provisioning
user: 'ubuntu'
password: 'ubuntu'
# Network address information for the head node:
#
# fabric_ip - the IP address and mask bits to be used to configure the network
# interface connected to the leaf - spine fabric
#
# management_ip - the IP address and mask bits to be used to configure the network
# interface connecting the head node to the POD internal
# management network. The head node will deliver DHCP addresses to
# the other compute nodes over this interface
#
# external_ip - the IP address and mask bits to be used to configure the network
# interface connecting the head node (and the POD) to the
# Internet. All traffic in the POD to external hosts will be
# NAT-ed through this interface
# external_iface - the name of the interface that connects the head node to the
# Internet
# management_network - the network and mask bits to used for hosts on the management
# network
fabric_ip: '10.6.1.1/24'
management_ip: '10.6.0.1/24'
external_ip: '47.135.132.21/24'
#external_iface: 'eth2'
management_network: 10.1.0.0/24
# the skipTags options allow various part of the deployment to be skipped
# switch_support - does not deploy switch boot images to the PXE server
#
# reboot - will not reboot the head node after updating its network configuration
# this may mean the network configuration will not take effect, but will
# also prevent you from being locked out of the server if there is a
# network configuration error.
#
# interface_config - will not modify the network configuration of the head node,
# including the consistent naming of the network interfaces
skipTags:
# - 'switch_support'
# - 'reboot'
# - 'interface_config'
docker:
imageVersion: candidate
otherNodes:
# Experimental
#
# Specifies the subnet and address range that will be used to allocate IP addresses
# to the compute nodes as they are deployed into the POD.
fabric:
network: 10.1.1.1/24
management: 10.1.0.0/24
range_low: 10.1.1.2
range_high: 10.6.1.253