| # SPDX-FileCopyrightText: 2020 The Magma Authors. |
| # SPDX-FileCopyrightText: 2022 Open Networking Foundation <support@opennetworking.org> |
| # |
| # SPDX-License-Identifier: BSD-3-Clause |
| |
| # |
| # log_level is set in mconfig. It can be overridden here |
| |
| prometheus: |
| ip: 0.0.0.0 |
| port: 8000 |
| |
| tr069: |
| interface: enp6s18 # NOTE: this value must be consistent with dnsmasq.conf |
| port: 48080 |
| perf_mgmt_port: 8081 |
| # NOTE: this is the IP which enodeb will communicate with enodebd |
| # if this is ever changed in dnsd.yml, this needs to be updated too |
| public_ip: 127.0.0.1 |
| |
| # Reboot eNodeB if eNodeB should be connected to MME but isn't |
| # This is a workaround for a bug with BaiCells eNodeB where the S1 connection |
| # gets into a bad state |
| reboot_enodeb_on_mme_disconnected: True |
| |
| # Enable webui for debugging for a list of eNB serial numbers. |
| # Not supported on all enodeb models |
| web_ui_enable_list: [] |
| |
| # Network interface to terminate S1 |
| s1_interface: eth1 |
| |
| # enodebd log_level - supported options: INFO, DEBUG, WARNING, ERROR, FATAl |
| log_level: INFO |
| |
| # firmware download information and credential used by enodebd |
| # for "filesize", calculated in Bytes, for device to check if it has enough space to download file |
| # put 0 to ask device to download the firmware anyway (but it may fail) |
| firmware: |
| url: "" |
| filename: "" |
| filesize: 0 |
| username: "" |
| password: "" |