| diff --git a/target/linux/brcm47xx/base-files/etc/init.d/netconfig b/target/linux/brcm47xx/base-files/etc/init.d/netconfig |
| index d7839b6..6446483 100755 |
| --- a/target/linux/brcm47xx/base-files/etc/init.d/netconfig |
| +++ b/target/linux/brcm47xx/base-files/etc/init.d/netconfig |
| @@ -150,6 +150,30 @@ start() { |
| } |
| } |
| } |
| + if (model == "D-Link DIR-330") { # boardtype is 0x0472, so we need to reset the parameters |
| + # The switch is on eth1, this script defaults to switch on eth0, so we write the values directly instead. |
| + print "#### DIR-330: eth1 must be up for configuring the switch " |
| + print "config interface switchport" |
| + print " option ifname \"eth1\"" |
| + print " option proto none" |
| + print "" |
| + print "config switch eth1" |
| + print " option enable 1" |
| + print "" |
| + print "config switch_vlan eth1_0" |
| + print " option device \"eth1\"" |
| + print " option vlan 0" |
| + print " option ports \"0 1 2 3 5t\"" |
| + print "" |
| + print "config switch_vlan eth1_1" |
| + print " option device \"eth1\"" |
| + print " option vlan 1" |
| + print " option ports \"4 5t\"" |
| + print "" |
| + c["lan_ifname"] = "eth0.0" |
| + c["wan_ifname"] = "eth0.1" |
| + } |
| + |
| # Buffalo WBR-B11 and Buffalo WBR-G54 |
| if (nvram["boardtype"] == "bcm94710ap") { |
| c["vlan0ports"] = "0 1 2 3 4 5u" |