| Wei-Yu Chen | 0f12b9c | 2019-04-18 11:12:59 -0700 | [diff] [blame^] | 1 | {{- /* |
| 2 | # Copyright 2018-present Open Networking Foundation |
| 3 | # Copyright 2018 Intel Corporation |
| 4 | # |
| 5 | # Licensed under the Apache License, Version 2.0 (the "License"); |
| 6 | # you may not use this file except in compliance with the License. |
| 7 | # You may obtain a copy of the License at |
| 8 | # |
| 9 | # http://www.apache.org/licenses/LICENSE-2.0 |
| 10 | # |
| 11 | # Unless required by applicable law or agreed to in writing, software |
| 12 | # distributed under the License is distributed on an "AS IS" BASIS, |
| 13 | # WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied. |
| 14 | # See the License for the specific language governing permissions and |
| 15 | # limitations under the License. |
| 16 | */ -}} |
| 17 | |
| 18 | This is the instruction to configure your eNodeB to work with ONF M-CORD. You can find architecture illustration in assets/mcord-architecture.png. |
| 19 | |
| 20 | 1. Check the eNodeB is operating in following information: |
| 21 | eNodeB Address: {{ .Values.enb.host }} |
| 22 | eNodeB S1 port: {{ .Values.enb.port }} |
| 23 | |
| 24 | 2. Configure eNodeB with the correct MME information, get MME IP by following commands: |
| 25 | export MMEIP=$(kubectl get --namespace {{ .Release.Namespace }} -o jsonpath="{.status.podIP}" pods mme-0 |
| 26 | export MMEPORT="36412" |
| 27 | |
| 28 | MMEPORT is fixed in templates/mme.yaml. |
| 29 | |
| 30 | 3. Make sure UE's SIM card information is configured in hss.yaml. |
| 31 | |
| 32 | 4. Attach UE to M-CORD. |