| # Deployment configuration for a physical hardware POD |
| --- |
| |
| # this is used to generate the genconfig/cord-inv file |
| headnode: |
| ip: '10.201.101.31' |
| ansible_user: 'cord' |
| ansible_ssh_pass: 'cord' |
| ansible_ssh_port: 22 |
| |
| common: |
| |
| # set to the profile of cord you want to install |
| cord_profile: 'rcord' |
| |
| # cord dir is shared to corddev VM, causing permissions issues if these aren't set |
| credentials_dir: '/opt/credentials' |
| pki_dir: '/opt/pki' |
| ssh_pki_dir: '/opt/ssh_pki' |
| |
| # all of these are written to genconfig/config.yml, and needs a rework |
| |
| # Network address information for the head node: |
| # |
| # fabric_ip - the IP address and mask bits to be used to configure the network |
| # interface connected to the leaf - spine fabric |
| # |
| # management_ip - the IP address and mask bits to be used to configure the network |
| # interface connecting the head node to the POD internal |
| # management network. The head node will deliver DHCP addresses to |
| # the other compute nodes over this interface |
| # |
| # external_ip - the IP address and mask bits to be used to configure the network |
| # interface connecting the head node (and the POD) to the |
| # Internet. All traffic in the POD to external hosts will be |
| # NAT-ed through this interface |
| fabric_ip: '10.6.1.1/24' |
| management_ip: '10.6.0.1/24' |
| external_ip: '10.201.101.31/24' |
| external_iface: 'eth2' |
| external_gw: '10.201.101.1' |
| skipTags: |
| extraVars: |
| - 'management_ignore_names=eth0' |
| |
| passwords: |
| compute_node: "ubuntu" |
| maas_admin: "admin" |
| maas_user: "cord" |
| |
| docker: |
| imageVersion: candidate |
| |
| otherNodes: |
| # Experimental |
| # |
| # Specifies the subnet and address range that will be used to allocate IP addresses |
| # to the compute nodes as they are deployed into the POD. |
| fabric: |
| network: 10.6.1.1/24 |
| range_low: 10.6.1.2 |
| range_high: 10.6.1.253 |
| |