blob: dfda974cfb4fd567c5c93f8e7b89858b1b94742e [file] [log] [blame]
# Deployment configuration for a physical hardware POD
---
# this is used to generate the genconfig/cord-inv file
headnode:
ip: '10.90.0.251'
ansible_user: 'cord'
ansible_ssh_pass: 'cord'
ansible_ssh_port: 22
common:
# set to the profile of cord you want to install
cord_profile: 'rcord'
# directories on the head node that the cord dir is copied to, and profile is created in
cord_dir: '/opt/cord'
cord_profile_dir: '/opt/cord_profile'
# all of these are written to genconfig/config.yml, and needs a rework
# Network address information for the head node:
#
# fabric_ip - the IP address and mask bits to be used to configure the network
# interface connected to the leaf - spine fabric
#
# management_ip - the IP address and mask bits to be used to configure the network
# interface connecting the head node to the POD internal
# management network. The head node will deliver DHCP addresses to
# the other compute nodes over this interface
#
# external_ip - the IP address and mask bits to be used to configure the network
# interface connecting the head node (and the POD) to the
# Internet. All traffic in the POD to external hosts will be
# NAT-ed through this interface
fabric_ip: '10.6.1.1/24'
management_ip: '10.6.0.1/24'
external_ip: '10.90.0.251/16'
external_iface: 'eth0'
external_gw: '10.90.0.1'
skipTags:
passwords:
compute_node: "ubuntu"
maas_admin: "admin"
maas_user: "cord"
docker:
imageVersion: candidate
otherNodes:
# Experimental
#
# Specifies the subnet and address range that will be used to allocate IP addresses
# to the compute nodes as they are deployed into the POD.
fabric:
network: 10.6.1.1/24
range_low: 10.6.1.2
range_high: 10.6.1.253