blob: 6f4fab681b9d0e42325239e1623c13803d32650f [file] [log] [blame]
Luca Pretefe0aeba2017-05-10 12:12:25 -07001# Deployment configuration for a physical hardware POD
2---
3
4# this is used to generate the genconfig/cord-inv file
5headnode:
6 ip: '10.201.101.31'
7 ansible_user: 'cord'
8 ansible_ssh_pass: 'cord'
9 ansible_ssh_port: 22
10
11common:
12
13 # set to the profile of cord you want to install
14 cord_profile: 'rcord'
15
16 # directories on the head node that the cord dir is copied to, and profile is created in
17 cord_dir: '/opt/cord'
18 cord_profile_dir: '/opt/cord_profile'
19
20
21 # all of these are written to genconfig/config.yml, and needs a rework
22
23 # Network address information for the head node:
24 #
25 # fabric_ip - the IP address and mask bits to be used to configure the network
26 # interface connected to the leaf - spine fabric
27 #
28 # management_ip - the IP address and mask bits to be used to configure the network
29 # interface connecting the head node to the POD internal
30 # management network. The head node will deliver DHCP addresses to
31 # the other compute nodes over this interface
32 #
33 # external_ip - the IP address and mask bits to be used to configure the network
34 # interface connecting the head node (and the POD) to the
35 # Internet. All traffic in the POD to external hosts will be
36 # NAT-ed through this interface
37 fabric_ip: '10.6.1.1/24'
38 management_ip: '10.6.0.1/24'
39 external_ip: '10.201.101.31/24'
40 external_iface: 'eth2'
41 external_gw: '10.201.101.1'
42 skipTags:
43 extraVars:
44 - 'management_ignore_names=eth0'
45
46passwords:
47 compute_node: "ubuntu"
48 maas_admin: "admin"
49 maas_user: "cord"
50
51docker:
52 imageVersion: candidate
53
54otherNodes:
55 # Experimental
56 #
57 # Specifies the subnet and address range that will be used to allocate IP addresses
58 # to the compute nodes as they are deployed into the POD.
59 fabric:
60 network: 10.6.1.1/24
61 range_low: 10.6.1.2
62 range_high: 10.6.1.253
63