Shad Ansari | 2f7f9be | 2017-06-07 13:34:53 -0700 | [diff] [blame] | 1 | iwf_mode=direct |
| 2 | # Mapping table between Qumran and Maple: 3-separate QaX/Maple SVKs, 4-SVK4 |
| 3 | intf_maptable=3 |
| 4 | num_nni_ports=1 |
| 5 | # UDP port where bcm.user listens for pkt_send messages from core (needed for remote bcm.user only!) |
| 6 | pkt_send_svr_listen_port=50002 |
| 7 | # UDP port where the core listens for pkt_rcv message from bcm.user (needed for remote bcm.user only!) |
| 8 | trap_udp_port=50001 |
| 9 | |
| 10 | # The following topology configuration (currently commented out) is an alternative for bal_topology.ini. |
| 11 | # In case both exist, bal_topology.ini takes precedence over this configuration. |
| 12 | topology.num_of_devs=1 |
| 13 | topology.num_of_pons_per_dev=2 |
| 14 | # Allowed pon modes are: gpon|xgpon|xgs|ngpon2|epon_tdma|epon_1g|epon_10g |
| 15 | topology.pon_mode=xgs |
| 16 | |
| 17 | #enable (y) or disable (n) loopback mode in MAC (does not need access to Maple HW if enabled) |
| 18 | #mac_loopback=y |
| 19 | |
| 20 | # Enable NNI auto-negotiation on NNI port <n>. |
| 21 | # It is known to work on NNI0 with some 1G transceivers, however |
| 22 | # this mode wasn't tested on NNI interfaces other than 0 and/or with different transceivers. |
| 23 | # Use at your own risk |
| 24 | # autoneg_nni<n>=y |